Critical power, abbreviated CP, is the highest power a cyclist can sustain for a long time. W′ is the finite amount of work they can spend above that power: the reserve for an attack. With these two numbers you can read what happens to the rider who attacks on a climb and to the one who has to respond.
In brief
- Critical power sits on average 7 W above FTP, but the two values can differ by anything from −19 to +33 W: they are not interchangeable
- At critical power you last less than half an hour; at a power close to FTP, about 55 minutes
- W′ is the reserve above CP, linked to sprint power
- In the classic model W′ is used up linearly above CP and rebuilt below it; in more recent studies W′ is not fixed
- The 3-minute all-out test is highly repeatable but overestimates CP
Take Selvino, 10.1 km at an average of 5.9%, one of the climbs of Il Lombardia 2026. The front of the race went up it in 26′46″. An amateur of 280 W and 75 kg, holding that power from the first metre to the last, would take 34′17″. That is a gap of 7′31″, and 280 W alone still does not say what that amateur can afford.
At 280 W and 75 kg, Selvino takes more than 34 minutes, and every effort above CP has to be paid for.
Critical power in one line, and W′ as a reserve
Above CP the reserve empties
The amateur rides a false flat at 250 W: below CP you last a long time, as the model says. Then the road kicks up and to hold the pace he has to push 300 W. Something changes. Suppose, for round numbers, that his CP is 280 W and his W′ is 20 kJ, that is 20,000 joules of work to spend above that threshold.
Below 280 W the body finds a balance and stays there. Above it, every extra watt is paid for with a piece of W′. At 300 W, twenty above CP, the reserve lasts about 1,000 seconds, almost 17 minutes. At 400 W, a hundred and twenty above, it lasts about 167 seconds: less than three minutes. The harder you push above CP, the faster the tank empties.
CP separates heavy intensity from severe
The boundary has a physiological basis. CP separates heavy from severe: below it lies heavy intensity, above it severe. It is the highest rate at which the muscle produces energy aerobically without its chemical balance gradually breaking down. In one study, working 10% above CP showed phosphocreatine falling and Pi and H+ rising relentlessly; 10% below, a steady state was reached. For our amateur that is 308 W against 252 W. How much oxygen consumption matters in all this is covered in the guide to VO2max in cycling.
The power-duration curve, read on the climb of Selvino
The sums
- 280 W ÷ 65 kg = 4.3 W/kg
- 280 W ÷ 75 kg = 3.7 W/kg
Selvino
10.1 km 5.9% average 596 m elevation gain
Enter a rider’s climbing time: the watts per kilo, with their range, and the VAM will appear here.
3.7 W/kg approx.
between 3.5 and 4.1 W/kg
- VAM
- 1,043 m/h
- Average speed
- 17.7 km/h
- Power
- about 280 W
| Power | Time | Speed |
|---|---|---|
| 5.0 W/kg | 26'50" | 22.6 km/h |
| 5.5 W/kg | 24'53" | 24.4 km/h |
| 6.0 W/kg | 23'15" | 26.1 km/h |
| 6.5 W/kg | 21'53" | 27.7 km/h |
| 7.0 W/kg | 20'43" | 29.2 km/h |
How we calculate it
Physical model by Martin and colleagues (1998): gravity, rolling resistance, air (on the rider and on the wheels) and bearing friction, at constant speed and gradient. Central assumptions: bike and equipment 8.0 kg, rolling resistance 0.0040, aerodynamic drag area 0.32 m², drivetrain efficiency 97.6%, air density 1.09 kg/m³ (average altitude 1,000 m), no wind.
The range is the result with all the favorable assumptions (drafting, a 1.5 m/s tailwind, a light bike) and with all the unfavorable ones (riding alone, a headwind, a heavier bike). These estimates are typically off by 6–10% (Millet, Tronche and Grappe, 2014): that’s why we never give a single number. A rider who surges and eases off spends a little more for the same time. VAM, the meters climbed in an hour, is a measurement instead: it depends only on elevation gain and time.
On the climbs, watts per kilo count
On the climbs, watts per kilo count, more than watts. The amateur’s 280 W mean one thing if he pushes them at 65 kg and another at 75: power on top, weight below, and the quotient decides the speed. On gradients like Selvino’s, gravity takes the biggest share of the effort, which is why the sum is so direct. The rest of the reasoning is in the guide to watts per kilo.
The power-duration curve is not a straight line
Now let us turn the question around: how many watts per kilo does it take to climb Selvino in a given time? To do it in 25 minutes takes plenty, to do it in 50 far fewer, and the relationship is not a straight line. Each extra minute is paid for with fewer watts per kilo, but with ever smaller discounts. That is the power-duration curve, and CP is the line it approaches without touching. The curve says what each time demands on this climb: it is not the curve of a single athlete.
The professional at the front of Il Lombardia, 65 kg and about 335 W, climbed Selvino in 26′46″: roughly 4.5-6.0 W/kg depending on the assumptions. Anyone with a time of their own on the climb can try it in the Climb timer, which turns it into watts per kilo, as a range.
How CP and W′ are derived from maximal efforts
To find the two numbers you need all-out efforts. You do three to five maximal trials, each between 2 and 15 minutes, at intensities between 80% and 105% of maximal aerobic power, and each taken to the end.
Then the inverse model is fitted to the points: power is the work W′ divided by time, plus CP. As a formula, P = W′/t + CP. Out come just two numbers: CP is the floor, the same whatever the duration; W′ is the part that weighs heavily in short trials and less and less in long ones.
With the two starting assumptions, CP 280 W and W′ 20 kJ, the formula gives about 391 W for 3 minutes, about 328 for 7 and about 308 for 12: a calculation, not measured trials. A simple rule also emerges: the shorter the trial, the more W′ decides; the longer it is, the more CP decides.
Critical power and FTP are not the same number
The amateur already knows a number that looks like a relative: his FTP. It is the highest power that can be held in a quasi-steady state for about an hour. In the study we use here it is derived from the 20-minute test, as 95% of average power: that is the method of that study, not an absolute rule. How it is measured is explained in the guide toFTP.
The study of 17 cyclists says the two values are close but not equal
The comparison was made on 17 trained cyclists and triathletes: CP derived from trials of 12, 7 and 3 minutes, FTP from a 20-minute trial. On average CP sat a little above FTP and the correlation was very strong: those with a high CP also had a high FTP.
But for the individual athlete the gap opened up. For some, FTP exceeded CP; for others, CP exceeded FTP by tens of watts: a spread of more than 50 W. If the amateur has an FTP of 280 W, his CP could fall anywhere between about 260 and about 313 W. They are not interchangeable, even though they move in the same direction.
That is why FTP lasts an hour and CP less than half an hour
Why does FTP end up below CP? In the study the 20-minute trial had an average power of 262 W and an average W′ of 16.6 kJ. 95% of 262 W is about 249 W, below the CP of about 256 W: the 5% discount is enough to put FTP underneath. The authors propose that the two-parameter model holds for efforts under 20 minutes.
How long you last also changes. In cyclists, trained and untrained, at critical power you last on average less than half an hour, about 23 minutes. At a power close to FTP you last almost an hour. For the amateur this means that pushing 280 W, if that were his CP, is not a pace to hold for the 34 minutes of Selvino: CP is not the one-hour power.
The W′ reserve is used up above CP and recharged below it
Back to the hardest stretch of Selvino, where the gradient reaches 9%. The amateur attacks at 400 W for one minute: he spends 120 W for 60 seconds, that is 7.2 kJ, more than a third of his reserve. Then he sits back up and drops below 280 W: the reserve starts to rebuild.
This is the classic model: above CP, W′ is used up linearly; below, it is restored; when it reaches zero you stop or have to drop below CP. The W′ balance comes from the work of Skiba and colleagues, and the first recovery time constant was derived from untrained people: in well-trained athletes recovery is faster.
Those with higher CP and threshold recharge faster
In a study of 13 competitive cyclists (average CP about 3.9 W/kg, average W′ about 21 kJ), five W′ reconstitution equations were tested on three interval protocols: 20 seconds of effort and 10 of recovery, and 60 and 30. None predicted zero at the moment the cyclists stopped. The authors point to an individual time constant as the solution.
Reconstitution depends mainly on aerobic parameters: the time constant was negatively correlated with CP relative to body weight and with the first lactate threshold, and recharges faster in those with higher CP and threshold. For the spectator this means that, for the same effort above CP, the rider with higher CP and threshold rebuilds the reserve sooner.
W′ is linked to maximal sprint power, to VO2max and to body mass. Its physiological basis remains partly elusive, but its decline is tied to the consumption of phosphocreatine and the accumulation of H+, Pi and ADP.
The professionals on the measured climbs of Il Lombardia 2026
The climbs of Il Lombardia 2026 show the curve in real numbers. San Fermo della Battaglia, climbed in about 6 minutes, demands about 6.7-8.3 W/kg on the first pass. Selvino, in almost 27 minutes, about 4.5-6.0 W/kg. The shorter the climb, the higher the watts per kilo; the line is not perfect: Giovenzana, in 13 minutes, sits below Civiglio, in 12.
These are not the professionals’ CP or W′ values, but the effort of that day. The times on San Fermo (6′10″ for Pellizzari, 6′17″ for Seixas) and on the Ghisallo are official; those for Civiglio, Giovenzana, Valpiana and Selvino are estimated from the live broadcast. On the Ghisallo the climbing is fast and air resistance accounts for more than 15%: the estimate is weak and not suitable for comparisons.
Whoever attacks on San Fermo spends their reserve in a few minutes; whoever climbs Selvino doses it over almost half an hour. To see where your own time would fall on one of these climbs, there is the Climb timer.
Where the model breaks down: W′ is not a fixed figure
The two-parameter model is simple, and in some situations it gets things wrong.
After an attack W′ behaves as if it were bigger
In 14 competitive cyclists, 9 men and 5 women, 70% of W′ was used up and then power was reduced while staying above CP. The work done was greater than predicted: +5.4 kJ after 90 seconds, +4.3 kJ after 180. For our amateur that would be about a quarter more reserve.
By reducing power in steps when W′ was theoretically at zero, the cyclists carried on beyond the predicted time: +256, +240 and +109 seconds in the three trials. The authors conclude that W′ is not fixed.
Earlier studies had found that spending it slowly, at about 112% of CP over 10 minutes, gave no extra work; at about 140% over 3 minutes it did. Perhaps the speed at which it is spent matters too.
The model simplifies and short tests estimate poorly
Above the severe zone the model tends to underestimate W′ consumption. Linear consumption assumes a constant mechanical efficiency, but during intense effort efficiency falls.
The 3-minute all-out test, used to estimate CP and W′ in one go, is highly repeatable: repeat it and you get similar results. But in a meta-analysis of 20 studies with 284 participants it systematically overestimated CP and estimated W′ poorly. Repeatable does not mean right.
What is left for those watching an attack on a climb
On Selvino, up front, nobody has a CP written on their back. The model serves another purpose: it gives a language to say that an attack has to be paid for. There is a floor you can hold and a reserve above it, and every extra watt drains it; there is no need to predict the exact second someone cracks.
The amateur knows it from his minute at 400 W: that sum adds up, even if the real numbers are messier and the reserve is not a fixed figure.
The intensity bands built around these numbers are in the guide to power zones. To set your own Selvino time beside that of the front of Il Lombardia, the Climb timer does the rest.
Written with the help of Mnemosyne.
Sources
- Karsten B., Petrigna L., Klose A., Bianco A., Townsend N., Triska C., “Relationship Between the Critical Power Test and a 20-min Functional Threshold Power Test in Cycling”, Frontiers in Physiology, 2020, PMID 33551839, doi:10.3389/fphys.2020.613151.
- Welburn A.J., Pugh C.F., Bailey S.J., Ferguson R.A., “W′ reconstitution modelling during intermittent exercise performed to task failure”, European Journal of Applied Physiology, 2026, PMID 40788399, doi:10.1007/s00421-025-05912-0.
- Welburn A.J., Bailey S.J., Ferguson R.A., “The effect of reducing work rate on total work done and time to task failure during severe intensity exercise”, European Journal of Applied Physiology, 2026, PMID 41222680, doi:10.1007/s00421-025-06046-z.
- Quittmann O.J., Piehl M.A., “The 3-min all-out test in cycling: a systematic review and meta-analysis on its reliability and validity”, European Journal of Applied Physiology, 2026, PMID 42479066, doi:10.1007/s00421-026-06356-w.
- “Il Lombardia 2026”, the race page: the climb times and our watts per kilo.